Fein ASW18-6 PC Manual De Instrucciones página 27

OBJ_BUCH-0000000390-001.book Page 27 Wednesday, June 12, 2019 7:40 AM
en
27
Operating instructions.
The power tool is not preset by the manufac-
turer for the intended application case.
In the factory setting, the configuration of the
machine parameters corresponds to the
homologation state (machine-specific
homologations can be found on the FEIN
website).
Through individual configuration of the
machine parametrization using FEIN Parame-
terControl software, the operating behavior
of the machine can change.
The power tool has a "MultiVolt" battery
interface, which allows for operation with dif-
ferent battery types. Depending on the type
of battery used, the operating behavior of the
machine can change.
Before starting operation, compliance with
the required process parameters must always
be checked individually for the respective
application under consideration of real oper-
ating conditions.
Regular control of the operating behaviour as
well as compliance with the required process
parameters shall be carried out to an appro-
priate extent.
During operation, pay attention to optical and
acoustic signals of the power tool as
described in the section "Meaning of the LED
indicators and the beeps of the power tool".