Transmitter Button Function - Dogtra 2600T&B Manual De Usuario

2. TRANSMITTER BUTTON FUNCTION

Locate
Pager
The transmitter for the 2600T&B Series has five buttons
(two on the face of the transmitter, two on the left side,
and one on the right side) and a toggle switch.
Nick Button
When the Nick button is pushed, the receiver emits a
single rapid pulse of electrical stimulation.
Constant Button
Pressing the Constant button gives continuous
stimulation as long as the button is pushed, for up to
12seconds. If the button is not released after 12 seconds,
the stimulation will automatically turn off as a safety
feature. The collar will be ready to be reactivated once
the button has been released.
54
Dog Collar
Toggle Switch
Nick
Constant
On/Off
Switch &
Mode
Locate Button
The Locate button is located on the left side. It causes
the collar's beeper horn to emit a series of beeps when
held down and gives you the ability to keep track of your
dog's location.
Note: The green collar emits the high tone and the
orange collar emits the low tone automatically.
If you want to change the tones, please contact us at
info@dogtra-europe.com or call customer service at +33
(0) 130 62 65 65.
Pager Button
The Pager button is located on the left side of the
transmitter. Pressing it will give a vibration for as long as
the button is pressed, for up to 12 seconds.
Mode Button
Your 2600T&B has three different modes: Locate, Run/
Point, and Point-Only. The Locate mode can be activated
at any time, even when another mode is set, by pressing
the top orange button labeled Locate on the left side
of the transmitter. To set the beeper unit to Run/Point
and Point-Only mode, press the black Mode button. This
button is located on the right side of the transmitter.
55