Add Stored Measures; Calculation Of Area / Volume; Battery Replacement; Precautions - Amprobe UDM45 Manual De Uso

Add stored measures

1. press 'ReAD' pushbutton to store a measured distance.
2. press'+/=' to enter the addition mode.
3. press 'ReAD' again to take another measurement.
4. press'+/= 'once again for adding the dimensions and the sum is shown on the display.
5. press' ReAD 'to cancel the addition mode.

Calculation of area / volume

1. press 'ReAD' to measure the length.
2. press 'x/=' to enter the multiplication mode.
3. press 'ReAD' to measure the width.
4. press 'x/=' and the calculated value of area is displayed in 'sq.'
5. press' ReAD' to measure the height.
6. press 'x/= 'and the result of he calculated volume is displayed in 'cu.'
• To end the area/volume calculation, just press 'ReAD' twice.
Note:
1. '+'and the times of adding will appear on the display during addition operation (but when
you press it more than 9 times, '-'displays); even more, adding can be done continuously.
2. The sum of the measurements cannot be used as an operand for multiplication.

BAttERy REpLACEMENt

1. Slide the lid of the battery compartment in the direction of the arrow to open it.
2. place the battery in the compartment and over the ribbon, as indicated by the markings of
the polarity (+ and -) symbols inside it.
3. put the lid back in place.
• As soon as the low-power warning appears, the battery must be replaced.
CAUtIoN
1. Dispose properly the bad battery. Do not burn or bury it.
2. At the end of its travel, the laser beam should always encounter a diffuse reflection material
(examples: a wooden plank).
3. Class 2 laser Radiation when on, do not stare into the laser beam.
4. Do not direct the beam in the direction of people or animals around you.

pRECAUtIoNS

if you do not plan to use your distance meter for a long period of time, remove the battery.
Batteries may spill chemical products that can destroy electronic parts.
6