Battery Installation; Power Off - Bushnell EQUINOX 260330 Manual De Instrucciones

BATTERY INSTALLATION

1. Open the battery compartment (9) by unscrewing and removing the battery cap (counter-clockwise).
2. Install two CR123 lithium batteries, inserted with the negative (flat) ends facing up towards the spring on the
removable cap.
3. Replace the battery compartment cap and secure it by turning it clockwise until tight.
NOTE: Do not mix old and new batteries together. Replace both batteries at the same time. Do not mix battery types.
POWER ON
Remove the protective objective lens cover (7) from the objective lens (6). Press the ON button (1) until the green
LED indicator (L1) turns on. The LCD screen inside the eyepiece (8) will power on.
FOCUSING
Point the Equinox night vision unit at the object you wish to observe, holding it horizontally with the ON button
and Bushnell logo facing up. To focus, first rotate the diopter setting ring of the eyepiece (8) until the edges of the
rectangular LCD screen appear as sharp as possible to your eye. Then rotate the objective lens focusing collar (6)
until the observed image is sharp. To focus on another object at a different distance, you will only need to adjust the
objective lens focusing collar (6), as the diopter setting is already optimized for your individual eyesight. You may
need to readjust the diopter setting the next time you use the Equinox unit or if the eyepiece is moved accidently.

POWER OFF

To turn the unit off, press the ON button (1) again. The green LED indicator (L1) will turn off. Replace the protective
objective lens cap cover (7) before storing or transporting the unit.
6