Low Battery Indicator - Bushnell EQUINOX 260330 Manual De Instrucciones

USING THE IR ILLUmINATOR
When using the unit under conditions of total darkness, turn on the IR illuminator (10) by pressing the IR button (2).
When the IR illuminator is on, the red LED indicator (L2) will turn on.
NOTE: The IR light source is invisible to the unaided eye, but can be seen by other people equipped with night vision
devices (be aware of this if using the unit for surveillance or law enforcement applications).
To turn the IR illuminator off, press the IR button (2). The red LED indicator (L2) turns off. (Note that the IR illuminator
does not cut off instantly, it will "fade out"). The IR illuminator will also turn off when the unit's power is turned off by
pressing and holding the ON button (1).
ADJUSTING THE LCD DISPLAY BRIGHTNESS
To increase and decrease LCD screen brightness, rotate the LCD brightness knob (3) until the desired level of
brightness is achieved to allow a comfortable viewing experience (clockwise rotation increases brightness).
NOTE: When the unit is turned on again, the LCD screen brightness setting will be at the same level as previously set.
SWITCHING THE LCD DISPLAY COLOR
To switch the LCD screen color from green to white or from white to green, quickly press the LCD backlight color
mode button (4).

LOW BATTERY INDICATOR

The green LED (L1) starts flashing when the battery power is less than approximately 15% of full capacity. Replace
both batteries as directed in "Battery Installation".
7