Mutsy NEXO Manual De Instrucciones página 15

Ocultar thumbs Ver también para NEXO:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

move the bumper bar from the frame.
Place the hood (p)
· Press the clips of the hood on the correct location on the frame. The
hood is fixed on the tubes of the frame. (p1)
· Subsequently, attach the fabric of the hood to the top of the back
support using the studs. (p2)
Adjust the hood (q)
· Hold the front hood bar in the centre and move it forwards or rear-
wards to adjust the hood (q1)
· Open the zipper in the centre of the opened hood in order to enlarge it.
(q2)
· Close the zipper to again reduce the hood.
· Pull the flap on the front side of the hood outwards to additionally en-
large the hood. Push the flap inwards to again reduce the hood.
Remove the hood (r)
· Release the studs at the top of the seat (r1). Then press the lip (r2) at the
bottom of the clips of the hood inwards and remove the hood.
Assemble the rain cover on the pushchair (s)
· Make sure that the hood of the pushchair is in the upright position.
· Possibly open the zipper in the rain cover to adapt it to the enlarged
hood of the pushchair.
· Place the rain cover from top to bottom over the pushchair and make
sure that the rain cover is attached well behind the back support and
over the footrest.
The 5-point safety harness (u)
· Place your child in the pushchair and make sure that the legs of your
child are placed on each side of the crotch strap.
· Make sure that the hip and shoulder belt is positioned correctly over
your child and place both plastic clamps in the central part of the har-
ness attached to the crotch strap.
· In order to adapt the length of the shoulder belts, you release the shoul-
der protection from the belt by pulling the Velcro loose. The straps of
the belt are now free in order to adapt the length. You adapt the length
by sliding the straps over the shoulder belts until both shoulder belts
properly harness your child. Slide the strap down to make the belt lon-
ger. Move the strap upwards to make the belt shorter. This will create
a loop in the belt. Hold on to the strap and pull the clamps to take the
10

Publicidad

Tabla de contenido
loading

Productos relacionados para Mutsy NEXO

Tabla de contenido