Install The Plumbing; Care And Cleaning - Kohler K-100 Guía De Instalación Y Cuidado

Install the Bath (cont.)
NOTE: The illustration shown may not represent your actual
product. The installation instructions still apply.
For All Installations
With help, carefully move the bath into the installation area.
Connect the tailpiece of the drain to the trap.
Verify the bath is: (1) level across the top of the bath, (2) plumb
along the drain side, and (3) resting on all four feet. If the bath is
not level, metal shims must be placed under the bath feet.
Level the Bath
Turn the leveling bolts at the bottom of the four legs.
Recheck if the bath is: (1) level across the top of the bath, (2)
plumb along the drain side, and (3) resting on all four feet.

4. Install the Plumbing

CAUTION: Risk of property damage. A watertight seal
must exist on all bath drain connections. The watertight seal
will prevent property damage.
Connect the trap to the drain.
Install the faucet valving according to the faucet manufacturer's
instructions. Do not install the faucet trim at this time.
Run water into the bath. Check the drain connections for leaks.
Fill the bath to the overflow. Check for leaks.
Install the faucet trim. Refer to the instructions packed with the
faucet trim.

Care and Cleaning

For best results, keep the following in mind when caring for your
KOHLER product:
• Always test your cleaning solution on an inconspicuous area
before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately
after applying cleaner. Rinse and dry any overspray that lands on
nearby surfaces.
• Do not allow cleaners to soak on surfaces.
1084218-2-C 6 Kohler Co.