Installation
•
Installation shall only be performed by qualified personnel and in accordance with local
governing regulations.
•
Do not route cable openly; instead run cable separately in a grounded metal conduit to
protect it from ambient electrical noise.
•
Seal all thread connections to prevent the ingress of moisture.
•
Do not run cable near high voltage or current runs, contactors or SCR control drives.
•
For pressure tight applications, install transducers hand tight plus ½ turn to 1½ turns.
PTFE tape or other appropriate sealant may be used to aid in sealing the threads for use
in pressure applications.
Improper installation may result in loss of process pressure.
WARNING:
Page EN-10
XLT Series Transducers - OPERATING MANUAL
A5E32280448