Environmental Protection; Declaration Of Conformity - Worx WORXSAW WX523 Manual Original

If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Periodically clear dust and chips from guard and
base to ensure proper performance.
TROUBLE SHOOTING
Symptom
Tool will not start when operating
the on/off switch.
Cutting depth is less than that
is set.
Blade spins or slips
Blade will not cut a straight line.
Blade kicks back when beginning
a cut
DECLARATION OF
CONFORMITY
We,
POSITEC Germany GmbH
Konrad-Adenauer-Ufer 37
50668 Köln
Declare that the product,
Description Battery-powered circular saw
Type WX523 WX523.9 (5-designation of
machinery, representative of Saw)
Function Cutting various materials with a
rotating toothed blade
Complies with the following Directives,
2006/42/EC
2011/65/EU
2014/30/EU
Lithium-Ion Cordless Circular Saw
ENVIRONMENTAL
PROTECTION
or retailer for recycling advice.
Possible Causes
Battery park not plugged in.
Battery park is powered off.
Carbon brush has worn down
Sawdust accumulated at the
rear of the base.
Blade is not tightly engaged
with the spindle.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided
properly.
Blade is not spinning fast
enough
Standards conform to:
EN 55014-1
EN 55014-2
EN 60745-1
EN 60745-2-5
The person authorized to compile the technical file,
Name: Russell Nicholson
Address: Positec Power Tools (Europe) Ltd, PO
Box 6242 Newbury RG14 9LT UK
Suzhou 2015/04/21
Allen Ding
Deputy Chief Engineer,Testing & Certification
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
Possible Solution
Check to make sure battery park is
connected well into a working outlet
Charging the battery.
Replace the carbon brush using a
qualified maintenance person.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Remove the blade, and reassemble
it as described in SAW BLADE
ASSEMBLY AND REMOVING
section.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Allow the saw blade to reach full
speed prior to beginning a cut in the
material.
15
EN