Mounting The Machine Side Hose Assembly - Abicor Binzel MT 452 W Instrucciones De Servicio

MT/AUT/AUT RAB

6.3 Mounting the machine side hose assembly

1
11
1 Hose assembly
2 Coolant return hose
3 Coolant supply hose
4 Re-circulating cooling unit
(only with liquid-cooled torches)
Fig. 5 Mounting the hose assembly on the machine side
1 Sharpen the beginning of the PA liner (9) to approx. 40° with the
ABICOR BINZEL sharpener (10).
2 Slide PA liner (9) through the wire feed hose (1) until a noticeable
resistance is felt in the contact tip.
3 Slide clamp nipple (8), O-ring (8) and union nut (3) on the PA liner (9) and
tighten the union nut (3) under tension.
4 Mark a PA liner (9) that is too long in front of the wire feed rollers.
5 Cut the PA liner (9) at the mark with the ABICOR BINZEL cutter (5) .
6 Sharpen the cutting point.
2
10 9
5 Wire basket spool
6 Shielding gas cylinder
7 Power supply
8 Wire feed unit
NOTICE
• Check once again whether the wire guide has been fastened correctly.
1 Combine central plug (10) and central socket (9) at the wire feed unit (8)
and secure them with the connecting nut (11).
6 Putting into operation
3
8
9 Central socket
10 Central plug
11 Connection nut
4
5
6
7
EN - 13