Setting The Shielding Gas Volume; Feeding In The Wire - Abicor Binzel MT 452 W Instrucciones De Servicio

MT/AUT/AUT RAB

6.5 Setting the shielding gas volume

6.6 Feeding in the wire

7 Operation
NOTICE
• The type and amount of shielding gas used depend on the welding task
and the gas nozzle geometry.
• Make all shielding gas connections gas-tight.
• To prevent the shielding gas supply from becoming clogged by
impurities, the cylinder valve must be opened briefly before connecting
the cylinder. This will expel any impurities that may be present.
CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
NOTICE
• Each time the wire is replaced, make sure that the start of the wire is free
of burrs and not bent.
 Fig. 5 Mounting the hose assembly on the machine side on page EN-13
1 Lay the hose assembly (1) straight out.
2 Insert the wire in the wire feed unit (8) as specified by the manufacturer.
3 Press the "Wire Jog" push-button at the wire feed unit (8) until the wire
comes out of the contact tip.
1 Open the shielding gas cylinder.
2 Switch on the power supply.
3 Setting the welding parameters.
4 Started welding.
7 Operation
EN - 15