Fitting The Handle And Handle Holder; Preparing The Connection To Chimney - Dovre Houtkachel 40CB Instrucciones De Instalacion Y Uso

Fitting the handle and handle
holder
The appliance is supplied with a loose handle, the so-
called "cold hand".
1. Fit the wooden handle to the adaptor using screw
M8x50 provided; see following figure.
09-20015.088
2. Fit the handle holder (A) supplied to the bottom
plate using the nut and bolt M8; see the following
figure.
Preparing the connection to
chimney
When connecting the appliance to the chimney you
have the choice of connecting via either the side, the
rear or the upper side. See the paragraphs
"Connecting on the side or to the rear" and
"Connecting to the upper side". It is also possible to
make a connection via the attachment 5T that can be
ordered separately; see the paragraph "Connecting
via the attachment 5T".
8
A special connection collar is required to connect
to the upper side of the appliance. This connection
collar (together with a cover) can be ordered
separately. The order number is 03.15317.020.
The appliance is not supplied with a flue gas
opening.
Sealant and materials supplied.
Connecting on the side or to the
rear
First of all, choose between the side or the rear to
connect the appliance to the chimney. Make the flue
gas opening on the side that you have chosen and
then fit the connection collar supplied with the
appliance.
For Germany, the appliance is supplied with a
connection collar with a diameter of 130 mm.
Make the flue gas opening in the appliance by
removing the connection cover. Use the equipment
provided: the tension piece, the washer, the nut and
bolt; see following figure.
1. In the centre of the connection cover, drill a hole
with a diameter of 10 mm.
2. Place the tension piece and the bolt on the inner
side of the connection cover.
3. Slide the washer over the bolt and tighten the nut
onto the bolt.
On enamelled appliances, place a piece of
cardboard measuring a minimum of 20 cm by
20cm between the washer and the appliance to
protect against chipping of the enamel.
Subject to change because of technical improvements