Silk’n BellaFlash Pro Manual Del Usuario página 16

E
EN
9.2 Treatments with Silk'n BellaFlash Pro
Follow these steps each time you treat an area.
1.
M
2.
3.
4.
5.
6.
7.
8.
Flash&Go Pro BellaFlash Pro UM NA 2102B inside ED131-01.indd 16
Use a lower energy level if you experience any discomfort.
Be sure to do a spot test for each part of the body you wish
to treat.
Before treating an area, the skin should be shaved, clean, dry and free
of any powders, antiperspirants or deodorants. Do not wax, pluck or
tweeze the hair out.
Be sure to cover up moles, warts or other marks on the skin
that should not be treated.
Press the control button. The device will turn on, the level 1 energy
indicator light will be on, and a fan sound will start.
Approximately 1 second after pressing the control button, the ready light
will turn on. The device is then ready to use at the lowest energy level.
Set the energy level. Press the control button repeatedly to increase
the energy level until you have the level you want. The energy level
indicator lights indicate the energy level setting (refer to section "8.2
Energy levels").
Decide if you wish to treat the area by Gliding or Pulsing (refer to section
"8.3 Pulsing and gliding").
Apply the treatment surface to the skin. Make sure that the skin is spread
evenly and smoothly. When the treatment surface is in full contact with
the skin, the ready light will start blinking slowly.
The device will first determine the color of your skin automatically, and
it will flash a pulse of light onto your skin. You will feel a mild sensation of
warmth and tingling, and you may hear a popping sound.
If you are pulsing, remove the device from your skin. The device
will immediately recharge for the next pulse. After a few seconds
(depending on the energy level) the ready light will turn on again, and
start blinking slowly when pressed against the skin.
16
20/03/2017 11:52:23