Attaching Trailer To Ball - Husky 32215 Montaje, Instalación, Operación Y Mantenimiento Instrucciones

18. Before hooking up the trailer to the hitch ball, adjust the height of the lift bracket so that the measured
distance from the ground to the bottom of the trunnion is the same (approximately) from the ground to
the top surface of the lift bracket.(Dimension "A" = Dimension "B" ±1 hole) this is a starting point and
you may need to make adjustments later. Using a 12 point 3/4" socket, tighten the (4) dog point set
screws 45-55 ft.-lbs.
Make sure the wheels on the trailer are chocked before connecting coupler to ball.
IMPORTANT! Ensure the tow vehicle and trailer is on level ground and in-line with each other.
Set parking brake of tow vehicle and chock the wheels of the trailer before lifting or lowering!
19. Back up the tow vehicle and align the hitch ball so that it is directly under the coupler socket (use a
spotter if you have one. CAUTION! Spotter should never stand between trailer and tow vehicle
during connecting). Then, lower the trailer until the hitch is supporting some of the trailer tongue
weight. The tow vehicle and trailer must be as straight and inline as possible.
20. Ensure the hitch ball is completely inside the coupler socket and close the coupler ball latch if it is not
yet closed. Install coupler lock or pin for safety.
Raise the front of the trailer and rear of the tow vehicle until the tips of the spring bars are about
21.
level/even with the support surface of the loading brackets.
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty
Information / Tech Support / Product Updates. ©2017 DTS Mfg. All Rights Reserved. April 30, 2018-Rev8
Spring bar support surface
GROUND/PAVEMENT

Attaching Trailer to Ball

15
Page