Chapin 97900 Instrucciones De Montaje página 10

6 Assemble Wand to Shut-off
Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
Turn and tighten the retaining nut clock-wise onto the shut-off valve.
FILLING THE SPRAYER
Make sure the filter basket is in place to keep debris from entering the tank.
Determine the amount of mixture needed for your application. Add the proper amount of water to the tank. Add the proper amount of chemical to
the tank (check the chemical label for proper ratio of chemical). Stir mixture in tank with a clean utensil (like a paint stirrer). The tank will hold the
12-gallon (45.4L) capacity plus the chemical.
It is not necessary to completely fill the sprayer tank with each use. You can fill the tank with only the amount needed for each application.
Always follow the manufacturer's instructions included on their product label.
OPERATING THE SPRAYER
• Plug in charged battery
• Turn switch to on position
• Spray liquid back into tank to prime pump
• Close shut-off. Pump should stop running.
• Replace cap & begin spraying.
When finished spraying turn switch to off position. Remove and re-charge battery.
Note: Unit is equipped with a battery protection circuit. If sprayer abruptly stops after spraying for an extended period of time, the battery
may require charging.
POWDER-BASED CHEMICALS
Powder-based chemicals (powder mixed with liquids to make the spraying agent) are usually abrasive and can cause wear. When you use a
powder-based chemical in your sprayer, make sure it is thoroughly dissolved in the liquid solution. Thoroughly clean and flush the sprayer with
water to extend the life of the sprayers parts.
CLEANING
• Always empty the sprayer and clean the tank thoroughly after each use.
Other Cleaning Tips:
• Improper spray distribution usually means the nozzle is clogged, remove the nozzle and clean it.
• Soap can be added to the water to clean the tank.
• Do not use strong cleaning agents or abrasives.
• If you use a chemical agent to clean the tank follow the manufacturer's recommendations for the disposal of the waste water.
• Follow the chemical manufacturers instructions for clean up.
Retaining Nut
Wand
O-ring
Shut-off
Valve