Chapin 97900 Instrucciones De Montaje página 5

WARNING: DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger and battery pack
are specifically designed to work together.
• These chargers are not intended for any uses other than charging designated Chapin
rechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
• Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock, or
electrocution.
• An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the
greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total
lenght, be sure each idividual extension contains at least the minimum wire size.
• Do not operate charger with damaged cord or plug - have them replaced immediately.
• Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to an authorized service
center.
• Do not dissassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk
of electric shock electrocution or fire.
• Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack
will not reduce the risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard household electrical power (120Volts). Do not attempt to use it on any other voltage.
Symbols
The label on your tool may include the following symbols.
V
Hz
min
SAVE THESE INSTRUCTIONS
volts
hertz
minutes
direct current
Class I Construction
(grounded)
Class II Construction
( double insulated)
Read instruction
manual before use
Use proper eye protection
A amperes
W watts
alternating current
no load speed
earthing terminal
safety alert symbol
/min or rpm revolutions or
reciprocation per minute
Use proper
respiratory protection
Use proper hearing protection