Emerson EUCLID CF500BS00 Manual Del Propietário página 7

BP7519 Euclid CF500-ESF.qxp_CF500 12/2/16 11:17 AM Page 7
3.5
Carefully turn the partially assembled fan right side up and
place on the styrofoam carton, in preparation for final
installation.
Remove the hanger ball by loosening the Phillips head set
screw in the hanger ball until the ball falls freely down the
downrod (Figure 5).
Remove the pin from the downrod, then remove the
hanger ball (Figure 5).
Retain the pin and hanger ball for reinstallation in
Step 3.11.
3.6
Separate, untwist and unkink the three 80" motor leads.
Route the three 80" black, blue, and white motor leads
through the downrod (Figure 6).
3.7
Loosen the two Phillips head set screws in the motor
coupler for installation of the downrod (Figure 7).
Seat the downrod in the motor coupler (Figure 7).
Rotate and align the downrod holes with all the holes in the
motor coupler (Figure 7).
3. Ceiling Fan Assembly
(Continued)
PIN
HANGER BALL
PHILLIPS HEAD SET SCREW (LOOSENED)
Figure 5
THREE 80" MOTOR
LEADS (UNTWISTED)
Figure 6
LOOSEN
PHILLIPS HEAD
SET SCREWS (2)
Figure 7
Please contact 1-800-654-3545 for further assistance
7
GREEN GROUND WIRE
4.5" DOWNROD
4.5" DOWNROD
4.5"
DOWNROD
MOTOR
COUPLING
emersonfans.com
U.L. Model No.: CF500