CAME ZL180 Repuestos Originales página 11

Electrical lock
ZL180 lets you connect, in two different modes, a 12V (15W max) electrolock and, if necessary, also
activate the "Ram Blow" function.
Mode 1 – Excludes use of the 2nd radio channel on B1-B2; after connecting it, operate as follows:
a) - Set dip switch 6 to ON (and dip switches 1, 2, 3, 4, 5 to OFF)
b) - press CH1: the red PROG led will start to blink
c) - when the led stays on (after about 5 seconds) the procedure is complete;
d) - set to the dip switches back to OFF (or to the previous position, which depends on the
functions selection, see page 12).
N.B.: to return to default (2nd radio channel on B1-B2), follow the same procedure while pressing CH2.
Modo 2 - Non permette il collegamento di una lampada spia su 10-5; dopo averla
connessa:
a a ) - Set ) - Set dip switches 2 and 6 to ON dip switches 2 and 6 to ON (and dip switches 1, 3, 4, 5 to OFF); ;
b b ), ), c c ), ), d d ) - continue with the above ) - continue with the above COMMON PROCEDUR
N.B.: to return to default (indicator lamp on 10-5), follow the same procedure while
pressing CH2.
In both modes, to activate the "ram blow"
a a ) - Set ) - Set dip switches 3 and 6 to ON dip switches 3 and 6 to ON (and dip switches 1, 2, 4, 5 to OFF); ;
b b ), ), c c ), ), d d ) - continue with the above ) - continue with the above COMMON PROCEDUR
N.B.: to exclude the ram blow, follow the same procedure while pressing CH2.
(1)
Upon each opening command, the gate leaves press on the closing jamb for one second, assisting the electrolock release operation.
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
B C
;
COMMON PROCEDURE.
(1)
:
COMMON PROCEDURE.
E
; ;
fuse in between
RALL1
transformer
terminal
10
RALL1
place
a 3.15 A transformer
terminal
5
B2
B1