CAME ZL180 Repuestos Originales página 13

Adjustment A
- «SPEED SENS.» Adjusts the amperometric sensitivity which controls the power developed by the motor during
motion; if the power exceeds the adjusted level, the system sets in motion to invert the direction of
motion.
- «SLOW.SENS.» Adjusts the amperometric sensitivity which controls the power developed by the motor during
slowing downs; if the power exceeds the adjusted level, the system sets in motion to invert the
direction of motion.
- «DELAY 2M» Adjustes the waiting time of the second motor during each closing run. The waiting time can be adjusted anywhere
between 1 and 17 seconds.
- «AUTOM. CLOSING» Adjusts the waiting time when gate is open. Once this time has elapsed, the gate closes automatically. The waiting
time can be adjusted anywhere between 1 and 150 seconds.
Activating the remote control
- Connect the antenna's RG58 cable to the apposite terminals.
- Lock the radiofrequency card into the electronic card
N.B.: the electronic card only recognises the radiofrequency card when the power is on.
Memorisation
CH1 = Channel for direct command to a function of the the gearmotor's
card, ("open only / "open-close-invert" or "open-stop-close-
stop" command, depending on the choice made on DIP
switches 2 and 3).
1) Keep the "CH1" button on the electronic card pressed. The LED PROG fl ashes.
2) Press the transmitter button you wish to memorise. The LED will stay on to show memorisation has been successful.
3) Repeat the points 1 and 2 procedures for the "CH2" button associating this to another button on the transmitter.
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
D
AFTER CUTTING OFF THE POWER SUPPLY (or after disconnecting the batteries).
B C
CH2 = Channel for direct command an accessory device connected
to B1-B2.