Product Description And Specifications; Product Features - Bosch GCM 80 SJ Manual Original

The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Symbols
The following symbols may be important for the operation of
your power tool. Please take note of these symbols and their
meaning. Correctly interpreting the symbols will help you to
operate the power tool more effectively and safely.
Symbols and their meaning
Keep hands away from the cutting area
while the power tool is running. Con-
tact with the saw blade can lead to injur-
ies.
Wear a dust mask.
Wear safety goggles.
Wear hearing protection. Exposure to
noise can cause hearing loss.
Danger area! Keep hands, fingers and
arms away from this area.
The adjustable fence must be pulled
outwards when sawing bevel angles.
To move the adjustable fence, the middle
locking screw must be loosened. Both ex-
ternal fastening screws must not be
loosened.
ø max.
Take note of the dimensions of the saw
216
blade. The hole diameter must fit the tool
spindle without play. If it is necessary to
use reducers, ensure that the dimensions
of the reducer are suitable for the base
blade thickness and the saw blade hole
diameter, as well as the tool spindle dia-
meter. Wherever possible, use the redu-
cers provided with the saw blade.
The saw blade diameter must match the
information specified on the symbol.
Bosch Power Tools
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended Use
The power tool is a stationary machine for cutting in a
straight line with and against the grain in hardwood, soft-
wood, chipboard and fibreboard. It is possible to cut mitre
angles of –47° to +47° and bevel angles of 0° to +45°.
When using appropriate saw blades, sawing aluminium pro-
files and plastic is also possible.

Product Features

The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Assembly holes
(2) Clamping screw for saw table extension
Saw table extension
(3)
(4) Recessed handles
(5) Scale for mitre angles
(6) Adjustable fence
(7) Screw clamp
(8) Stop for standard 45° bevel angle
(9) Stop screw for 45° bevel angle
(10) Clamping handle for all bevel angles
(11) Locking screw for slide device
(12) Slide device
(13) Chip ejector
(14) Chip deflector
(15) On/off switch
(16) Handle
(17) Locking switch for releasing the tool arm
(18) Protective guard
(19) Retracting blade guard
(20) Guide roller
(21) Fence
(22) Saw table
(23) Insert plate
(24) Angle indicator for mitre angles
(25) Locking knob for all mitre angles
(26) Mitre pre-setting lever
(27) Tilt protector
(28) Detents for standard mitre angles
(29) Spindle lock
English | 23
1 609 92A 5UB | (22.10.2020)