Cleaning Under Running Water; Thorough Cleaning - Silvercrest SRR 3.7 C3 Instrucciones De Uso

2) Tap the cutting unit
cuttings.
3) Use the brush
4) Replace the cutting unit
snaps into place and is seated firmly.
Long hair trimmer
■ Clean the long hair trimmer
brush .
■ Oil the long hair trimmer
of sewing machine oil.

Cleaning under running water

1) Take hold of the cutting unit
recesses
2) Hold the cutting unit
flows through the shaving heads from the inside to the outside.
CAUTION! MATERIAL DAMAGE!
Hold only the cutting unit
handset can be damaged irreparably if it is held under running
water.
3) Allow the cutting unit
4) Replace the cutting unit
snaps into place and is seated firmly.

Thorough cleaning

To clean the appliance thoroughly, disassemble the three cutting
heads:
1) Take hold of the cutting unit
recesses
SRR 3.7 C3
on a flat surface or blow off the hair
to remove any remaining hair cuttings.
flush on the appliance. Ensure that it
around every 6 months with a drop
and pull it off.
under the running water so that the water
to dry.
flush on the appliance. Ensure that it
and pull it off:
after every use with the supplied
with three fingers in the grip
under running water! The shaver
with three fingers in the grip
GB │ IE │
35 ■