Removing The Secure Router 2330 Internal Scim Module; Installing The Secure Router 2330 Internal Pvim Module - Nortel Networks 2330 Manual Del Usario

28 English

Removing the Secure Router 2330 internal SCIM module

Use the procedure in this section to remove a SCIM module from the
Secure Router 2330.
•
Ensure you have a Phillips #1 screwdriver.
•
Ensure the Secure Router 2330 is powered off. You cannot hot swap
internal components.
•
Ensure you have an antistatic bag or sheet available for the SCIM that
you are removing.
Procedure steps
Step
1
2
3
4

Installing the Secure Router 2330 internal PVIM module

Use the procedure in this section to install an internal PVIM module.
•
Ensure you have a PVIM module ready to install before opening the
chassis top cover.
•
Ensure you have a Phillips #1 screwdriver.
•
Ensure the Secure Router 2330 is powered off. You cannot hot swap
internal components.
Action
Remove the Secure Router 2330 top cover. See Removing the
Secure Router 2330 top cover.
DANGER
Do not open the Secure Router 2330 top cover while
the unit is powered.
Remove the screw that secures the SCIM module to the Main
Board.
Grasping the edges of the SCIM module, pull the module up and
off of the Main Board connector on which it is seated.
If you are not installing a SCIM module at this time, replace the
chassis top cover.
Nortel Secure Router 2330/4134
Regulatory Information
NN47263-106 01.01 18 September 2009
Copyright © 2009- Nortel Networks. All Rights Reserved.
--End--