Secure Router 4134 Internal Module Installation And Removal; Removing The Secure Router 4134 Service Access Panel - Nortel Networks 2330 Manual Del Usario

Secure Router 4134 internal module installation and removal

This section provides information for installing and removing Secure
Router 4134 internal modules.

Removing the Secure Router 4134 service access panel

Use the instructions in this procedure to remove the Secure Router 4134
service access panel.
•
Ensure you have a module ready to install before opening the service
access panel.
•
Ensure you have a Phillips #2 screwdriver.
•
Ensure the Secure Router 4134 is powered off. You cannot hot swap
internal components.
Step Action
1 Remove the two screws at the rear of the Secure Router 4134
that hold the service access panel secure. Remove these two
screws only.
See the following figure for reference.
2 Slowly slide the access panel toward you until it is clear of the
Secure Router 4134.
NN47263-106 01.01 18 September 2009
Copyright © 2009- Nortel Networks. All Rights Reserved.
DANGER
Do not open the Secure Router 4134 service access panel while
the unit is powered.
Nortel Secure Router 2330/4134
Regulatory Information
Secure Router 2330/4134 modules 31
--End--