Installing The Secure Router 4134 Internal Vpn/Ipsec Module - Nortel Networks 2330 Manual Del Usario

32 English

Installing the Secure Router 4134 internal VPN/IPSec module

Use the procedure in this section to install an internal VPN/IPSec module.
•
Ensure you have a VPN/IPSec module ready to install before opening
the service access panel.
•
Ensure you have a Phillips #2 screwdriver.
•
Ensure the Secure Router 4134 has the power switched off.
Procedure steps
Step
1
2
3
Action
Remove the Secure Router 4134 service access panel. See
Removing the Secure Router 4134 service access panel.
DANGER
Do not open the Secure Router 4134 service access
panel while the unit is powered.
Locate the internal VPN/IPSec module connector slot.
Holding the VPN/IPSec module by its edges, align the connector
with the slot on the Main Board, pushing down gently, but firmly,
to seat the module.
The following figure shows the location for installing the
VPN/IPSec module.
Nortel Secure Router 2330/4134
Regulatory Information
NN47263-106 01.01 18 September 2009
Copyright © 2009- Nortel Networks. All Rights Reserved.