Removing The Secure Router 4134 Internal Vpn/Ipsec Module - Nortel Networks 2330 Manual Del Usario

4 Using a Phillips screwdriver, tighten the two screws that secure
the module to the Main Board.

Removing the Secure Router 4134 internal VPN/IPSec module

Use the procedure in this section to remove a VPN/IPSec module from the
Secure Router 4134.
CAUTION
The internal VPN/IPSec module is not hot swappable. Do not
open the Secure Router 4134 service access panel while the
unit is powered.
•
Ensure you have a Phillips #2 screwdriver.
•
Ensure the Secure Router 4134 has the power switched off. You
cannot hot swap internal components.
•
Ensure you have an antistatic bag or sheet available for the
VPN/IPSec that you are removing.
Nortel Secure Router 2330/4134
Regulatory Information
NN47263-106 01.01 18 September 2009
Copyright © 2009- Nortel Networks. All Rights Reserved.
Secure Router 2330/4134 modules 33
--End--