Switching On For The First Time - SEVERIN S2 One Touch Instrucciones

US
Fig. 2: Inserting the water filter

5. Switching on for the first time

When you switch your device on for the first time, it first asks you for some basic set-
tings.
1. Plug the mains plug into the outlet.
2. Switch the device on with the on/off switch.
The display shows:
Â
Please select language
3. Turn the e-Select until the desired language is shown and confirm it by pressing
the e-Select.
The display shows:
Â
Please select water hardness
4. Check the water hardness on a tap using the water hardness test strip. To do
this, proceed according to the enclosed description of the test strips.
5. Use the e-Select to select the water hardness and confirm your entry.
8
Fig. 3: Inserting the water tank
The display shows:
Â
use filter?
6. Rinse the water tank thoroughly with water.
7. If desired, insert the "Limpid" water filter into the water tank (Fig. 2) the water tank
with cold drinking water up to the „Max" marking and insert it into the device
(Fig. 3). Here, mre that the water tank hooks into the top of the device and lies
close against the device.
NOTE!
A water filter improves the water quality of the water used
by removing contaminants from the water. SEVERIN
recommends the use of the "Limpid" water filter for high
water quality.
8. Select with the e-Select
• , if you do not want to use a water filter or
no
• , if you want to insert a water filter in the water tank.
Yes
Version 1 2011-04-18