Preparing Coffee With Coffee Powder - SEVERIN S2 One Touch Instrucciones

The display shows:
Â
quantitY
and below this a bar with the set quantity in „ml". The coffee dispensing
stops automatically, but it can also be stopped by pressing the e-Select.
After the preparation, the display shows the following for a short while:
clean milk unit?
8. Press
• the button to perform the cleaning (see „8.'8.3.2 Cleaning the milk
unit' on page 20) or
• the button if you only want to perform the cleaning later.
NOTE!
It is recommended that you clean the milk unit after each
preparation.
6.4

Preparing coffee with coffee powder

You can also prepare a coffee specialty with coffee powder. This is especially useful if
you want to prepare a decaffeinated coffee, for example.
1. Proceed as described in the se'6.3.1 Preparing coffee or espresso'sso" '6.3.2
Preparing coffee-milk specialties'" to select the desired beverage.
2. Instead of selecting the strength of the coffee, use the
symbol.
3. After you have selected the desired water and milk quantities, press the e-Select.
The display shows
Â
Please add coffee Powder
4. Open the cover of the bean container and fill the powder dosing chamber with
coffee powder.
Version 1 2011-04-18
5. Turn the powder dosing chamber over (Fig. 7).
6. Turn the powder dosing chamber back to the initial position and close the cover
of the bean container.
7. Press the e-Select again.
Â
8. To make changes to the liquid quantities while drawing, turn the e-Select as de-
scribed in the sections '6.3.1 Preparing coffee or espresso' repar '6.3.2 Preparing
coffee-milk specialties'
button to select the
CAUTION!
Incorrect filling can damage the device.
– Only add coffee when the device asks you to.
– Only add coffee made of ground beans (no instant
beverage powder, coffee granules, cocoa, etc.).
– Fill the powder dosing chamber just once for a cup
portion, not multiple times.
The desired coffee specialty is prepared.
US
13