INSTALLATION
1. LATCH BACKSET ADJUSTMENT
Latch backset adjustment applies only when your door needs a 2-3/4 in. (70 mm) backset.
Please follow below diagrams. Skip this if your door is for a 2-3/8 in. (60 mm) backset.
For 2-3/4 in.
(70 mm) backset
Using a flathead screwdriver (not included), turn the screw
on the latch (J) counterclockwise to extend the latch bolt.
Twist back 1/8 turn.
Using a flathead screwdriver (not included), turn the screw
on the latch (J) clockwise 90º to retract the latch bolt.
Twist 1/8 turn and pull.
09
4