Gate House G27D01 Manual Del Usuario página 32

TROUBLESHOOTING
PROBLEM
Yellow LED light keeps
flashing.
Keypad does not respond.
Programming code cannot
be changed.
Code incorrectly input.
CORRECTIVE ACTIONS
The battery is getting low. Replace ALL batteries
for best performance. Only use alkaline batteries.
1. Check battery installation.
2. The battery is low if the yellow LED light keeps
flashing. Please replace all batteries.
3. Make sure the power strip is well-connected to the port.
1. Complete the "CHANGE PROGRAMMING CODE"
process by inputting codes within 10 seconds.
2. Please make sure you have entered the new
programming code correctly or go back to the
factory setting (refer to page 25) and then reset
the program again.
Press button once and continue to input code
C
according to regular procedures.
30