Descaling
If the water in your area is hard, limescale builds up over time.
These deposits may affect correct operation of the appliance.
You are recommended to descale the coffee maker every 60 cof-
fee making cycles. To descale, always use special commercially
available descaling products for drip coffee makers.
1. Dilute the product in the jug, following the instructions on
the descaler pack.
2. Pour the solution into the water fill compartment.
3. Place the jug on the warming plate (M).
button (L), percolate the equivalent of one
4. Press the
cup then turn the appliance off.
5. Leave the solution to work for 15 minutes, then repeat op-
erations 4 and 5.
6. Turn the appliance on and deliver the water until the tank
is completely empty.
7. Rinse by operating the appliance with water only at least 3
times (3 complete tanks of water).
Failure to clean as described above invalidates the guarantee.
Technical data
Mains voltage:
Absorbed power:
Weight:
Disposing of the appliance
In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with household
waste, but taken to an authorised waste separation
and recycling centre.
The appliance complies with the following EC directives:
•
Low V oltage Directive 2006/95/EC and subsequent amend-
ments;
• EMC Directive 2004/108/EC and subsequent amendments
• EC Regulation 1275/2008 for standby
Troubleshooting
Problem
Probable cause
The
coffee
The coffee maker
takes longer
needs to be desca-
to brew.
led.
The
coffee
Insufficient rinsing
has an acidic
after descaling.
taste.
220-240V ˜ 50/60Hz
1000W
2.5 kg
Solution
Descale the machine
as described in the
section DESCALING.
Rinse the machine
as described in the
section DESCALING.
11