Technical Data; Tips For Energy Saving; Displayed Messages - DeLonghi ELETTA CAPPUCCINO EVO ECAM4686X Manual De Instrucciones

Ocultar thumbs Ver también para ELETTA CAPPUCCINO EVO ECAM4686X:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Please note:
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.

15. TECHNICAL DATA

Voltage:
Absorbed power:
Pressure:
Max. water tank capacity:
Size LxDxH:
Cord length:
Weight:
Max. beans container capacity:

16. DISPLAYED MESSAGES

DISPLAYED MESSAGE
Fill tank
Insert tank
Empty grounds container
Insert grounds container
Add pre-ground coffee
ESC to cancel
Add pre-ground coffee
ESC
OK
120 V~ 60 Hz
1250W
1.5MPa (15 bars)
2 l
260x470x360 mm
1200 mm
11 kg
380 g
POSSIBLE CAUSE
Insufficient water in the tank (A14).
The tank (A14) is not correctly in place.
The grounds container (A17) is full.
After cleaning, the grounds container (A17)
has not been replaced.
The pre-ground coffee function has been se-
lected without placing any pre-ground coffee
in the funnel (A4).
A LONG coffee with pre-ground coffee has
been requested
De'Longhi reserves the right to modify the technical specifica-
tion and styling of its products at any moment, without com-
promising their functionality and quality.

15.1 Tips for Energy Saving

To reduce energy consumption, after delivering one or
more beverages, remove the container (D) or accessories.
Set auto-off to 15 minutes (see section "6.4 General");
Enable Energy Saving (see paragraph "6.4 General");
When requested by the machine, perform the descaling
cycle (see section "12. Descale").
REMEDY
Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place (fig. 4).
Insert the tank correctly and press as far as it
will go (fig. 4).
Empty the grounds container and drip tray
(A19), clean and replace. Important: when
removing the drip tray, the grounds contain-
er MUST be emptied, even if it contains few
grounds. If this is not done, when you make
the next coffees, the grounds container may fill
up more than expected and clog the machine.
Remove the drip tray (A19) and insert the
grounds container.
Place pre-ground coffee in the funnel or dese-
lect the pre-ground function.
Put one level measure of pre-ground coffee
into the pre-ground coffee funnel (A4) and
press
preparation.
20
(B11) to continue and complete

Publicidad

Tabla de contenido
loading

Tabla de contenido