Nice Era Fit P Serie Instrucciones Y Advertencias Para La Instalación Y El Uso página 6

5.7 - Guided High ("0") and Low ("1") limit switch recognition
This procedure matches the motor rotation direction with the s and t keys on the control device, so that the s key raises the rolling shutter and the t key lowers it.
Note – When the limit switches are memorized with this procedure, the two heights are controlled and updated constantly by the "limit switch self-update" function
(see paragraph 6.3).
Before starting the procedure, bring the rolling shutter to the midpoint of its stroke.
01. Run the Raise command by keeping the s (or t) keys pressed and wait for the rolling shutter to stop automatically as result of the impact of the safety plugs
against the structure (= upper limit switch "0"). Upon completion, release the key.
02. Run the Lower command by keeping the t (or s) key pressed and wait for the rolling shutter to stop automatically as result of the impact of the rigid anti-intru-
sion springs against the structure (= lower limit switch "1"). Upon completion, release the key.
01
––––––––––
Note – After programming, the s key will command the Raise motion and the t key will command the Lower motion. If the result is not as expected, delete the limit
switch heights (procedure 5.11) and repeat the limit switch recognition process.
5.8 - Enabling automatic High ("0") and Low ("1") limit switch recognition
This procedure matches the motor rotation direction with the s and t keys on the control device, so that the s key raises the rolling shutter and the t key lowers it.
Limit switches will be automatically programmed later on during the first 2-3 manoeuvres for opening and closing the rolling shutter.
Warning – When the limit switches are memorized with this procedure, the two heights are controlled and updated constantly by the "limit switch self-update" function
(see paragraph 6.3).
Before starting the procedure, bring the rolling shutter to the midpoint of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the s and t keys pressed simultaneously and wait for the motor to perform 3 movements. Upon completion, release the keys.
03. Hold down the s key and,
• if the rolling shutter starts to Rise continue to hold the s key down and wait for the motor to perform 3 movements. Upon completion, release the key.
• if the rolling shutter starts to Lower, release the s key and hold down the t key, waiting for the motor to perform 3 movements. Upon completion, release the
key.
01
5
sec.
03
...
sec.
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5 – English
ATTENTION! – Programming intended exclusively for rolling shutters with mechanical
blocks for the limit switch.
"0"
ATTENTION! – Programming intended exclusively for rolling shutters with mechanical
blocks for the limit switch.
02
2
3
02
3
5
sec.
THE
END
END
6
sec.
"1"
THE
END
3
END
THE
END
END