Nice Era Fit P Serie Instrucciones Y Advertencias Para La Instalación Y El Uso página 9

5.11 - Total or partial deletion of memory
This procedure allows you to choose under point 05 the data that you want to delete.
Procedure performed with a transmitter memorized in "Mode I"
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04. Keep the t key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
05. • To cancel the entire memory: Keep the s and t keys pressed and wait for the motor to perform five movements. Upon completion, release the keys.
• To delete only the memorized transmitters: do not press any key and wait until the motor performs five movements.
• To delete only the limit switch heights and intermediate heights: ATTENTION! - This deletion must be performed only when you want to adjust
the limit switch heights again, using a different procedure than the one used previously. Keep the n key pressed and wait for the motor to perform 5
movements. Upon completion, release the key.
01
2
5
sec.
04
3
5
sec.
ATTENTION!
This deletion must be performed only when
you want to adjust the limit switch heights
again, using a different procedure than the
one used previously. Whereas if you want to
adjust heights with the same procedure, it is
not necessary to delete them from memory.
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
02
3
5
sec.
all
data
"0"
"1"
"H"
only
03
3
5
sec.
05
5
5
sec.
05
5
5
sec.
05
THE
END
5
END
THE
END
END
THE
END
END
English – 8