Nice Era Fit P Serie Instrucciones Y Advertencias Para La Instalación Y El Uso página 7

After completing the procedure, command a manoeuvre to check that the key pressed corresponds to the right direction of shutter movement. If it
does not correspond, perform procedure 5.8.1 to reset the original settings and then repeat procedure 5.8.
––––––––––
Note – After programming, the s key will command the Raise motion and the t key will command the Lower motion. The shutter will move within the limits created
by the mechanical blocks of the limit switches.
5.8.1 - Disabling automatic recognition (for maintenance or restoration of factory settings)
Before starting the procedure, bring the rolling shutter to the midpoint of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the s and t keys pressed simultaneously and wait for the motor to perform 3 movements. Upon completion, release the keys.
03. keep pressed the n key and wait for the motor to perform 5 movements. Upon completion, release the key.
01
5
sec.
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.9 - Adjusting height ("H") for partial opening/closing
The motor can manage up to 30 partial openings/closings, each called "H height". These heights can only be adjusted after adjusting limit switches "0" and
"1". The following procedure makes it possible to adjust one "H" height at a time.
Warnings – If you want to change the position of a given "H" height that is already memorized, repeat the present procedure by pressing the key associated
with that height at point 06.
Before beginning the procedure, bring the rolling shutter to the "H" height you want to memorize.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the n key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
03. Keep pressed the s and t keys simultaneously and wait for the motor to perform two movements. Upon completion, release the keys.
04. Fine adjustment of position: Perform key pulsing on the s key and t key until the rolling shutter is brought to the partial height you want (at each pulse the
rolling shutter moves a few millimetres).
05. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
06. • To memorize the FIRST "H" height: on the transmitter you are using for this procedure, keep the s and t keys pressed simultaneously and wait for the
motor to perform 4 movements. Upon completion, release the keys.
• To memorize the NEXT "H" height: on the new unmemorized transmitter keep the desired key pressed and wait for the motor to perform 4 movements. Upon
completion, release the key.
01
"H"
5
sec.
04
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
02
2
02
2
05
"H"
3
5
sec.
(other transmitter)
3
5
sec.
4
5
sec.
first
pos.
"H"
next
pos.
"H"
03
5
5
sec.
03
2
5
sec.
06
4
5
sec.
06
4
5
sec.
THE
END
END
THE
END
END
THE
END
END
English – 6