Nice Era Fit P Serie Instrucciones Y Advertencias Para La Instalación Y El Uso página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
5.10 - Memorizing a SECOND (third, fourth, etc.) transmitter
To perform this procedure you must have a second transmitter ("old") already memorized.
5.10.1 - Memorizing a second transmitter "Mode I"
Attention! – This procedure memorizes the new transmitter in "Mode I", regardless of the Mode in which the old to transmitter was memorized.
01. (on the new transmitter) keep the n key pressed for 8 seconds and then release it (in this case the motor does not perform any movement).
02. (on the old transmitter) Press any key which has already been memorized three times (the motor will start performing the manoeuvre associated with that key).
03. (on the new transmitter) Give for one pulse to the n key to complete the procedure. Attention! – If the motor performs 6 movements, it means that its memory is
full.
01
sec.
New
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.10.2 - Memorizing a second transmitter in "Mode II"
Attention! – This procedure memorizes the new transmitter in "Mode II", regardless of the Mode in which the old to transmitter was memorized.
01. (on the new transmitter) Hold the key to be memorized down for 8 seconds (for example: the n key), then release it (in this case the motor does not perform any
movement).
02. (on the old transmitter) Keep the n key pressed and wait for the motor to perform 4 movements. Upon completion, release the key.
03. (on the old transmitter) Briefly press the n key a certain number of times depending on the and you want to memorize:
1 pulse = step-by-step command
2 pulses = Open > Stop > Open > Stop > command...
3 pulses = command Close > Stop > Close > Stop > command...
4 pulses = Stop command
After about 10 seconds, the motor performs a number of movements equal to the number impulses given with the transmitter.
04. (on the new transmitter) Press the same key as you pressed in point 01 and hold it down while the motor performs 3 movements. Upon completion, release the
key. Attention! – If the motor performs 6 movements, it means that its memory is full.
example
01
sec.
New
03
Old
same
04
01
New
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
7 – English
example
02
8
Old
02
8
Old
x 1 = Step-By-Step
x 1 = Passo-passo
x 2 = Open > Stop > ...
x 2 = Apri > Stop > ...
x 3 = Close > Stop > ...
x 3 = Chiudi > Stop > ...
0,5
sec.
x 4 = Stop
x 4 = Stop
3
5
sec.
03
X 3
0,5
sec.
4
5
sec.
?
10
sec.
THE
END
END
THE
END
0,5
END
sec.
New
1 /
2 /
3 /
4 /

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

E fit spE fit mp

Tabla de contenido