Installation And Start-Up; Technical Specifications - Tripp-Lite APSX1012SW Manual Del Propietário

4. Installation and Operation

4.3 Installation and Start-Up

4.3.1
Connect the unit to the batteries per Section 3. Ensure that the nominal DC battery voltage is 12V.
4.3.2
Connect the unit to the AC load. Then connect to the AC source. Confirm that all wiring is correct and terminal is tight.
4.3.3
Press the ON/OFF button. The system will start working after a few seconds. If the AC source power fails, the unit will work in
Inverter mode. Otherwise, the system will switch to AC Mode and will power the load while charging the battery.

5. Technical Specifications

Specification
Continuous Power
Peak Inverter Efficiency
Output Waveform
DC Current at Rated Power
Recommended Battery Fuse
Nominal Input Voltage
DC Input Voltage Range
Low Battery Protection (Heavy/Light Load)
DC Mode Output Voltage Regulation
Power Factor Allowed
Frequency Regulation
Standard Output Voltage
Load Sensing (Power Saving)
Transfer Time
Forced Air Cooling
Automatic Transfer Relay
Adjustable Charge current
Resistive Load
Inductive Load
Motor Load
Rectifier Load
Wall-Mounting
201110117 93-3054.indb 11
Model
APSX1012SW
1000 Watts
>82%
Sine Wave
120 Amps
200 Amps
12 VDC
10.0 ~ 16 VDC
10.9/11.2 VDC
+/- 10%
0.8 to 1
50/60 Hz, +/- 0.5 Hz (Autoselect)
230 VAC
100W
16 ms max
Variable Speed
15A
4 ~ 40 A
100%
11
APSX2012SW
2000 Watts
240 Amps
400 Amps
30A
6 ~ 60 A
YES
YES
YES
YES
11/9/2011 10:57:58 AM