Festo DDPC Instrucciones De Utilizacion página 19

DDPC
In the case of direct fastening or use of mounting accessories in each case with cylinder collar hole
milling:
• Select a mounting option (e.g. from the following table).
Double screw connection with HNC foot
mounting in the threaded holes of the cover
screws
Tab. 2
• Tighten the mounting screws evenly.
The different product sizes have the following connecting threads and tightening torques:
Size
Connecting thread
Tightening torque
Tab. 3
If accessories are mounted on the piston rod:
• Use the following elements:
– only the thread of the piston rod.
– the square piston rod 5 for counter pressure
(only in the retracted end position).
The maximum torque on the bearing must not exceed 5 Nm.
– an external guide for the work load.
This will prevent lateral loads on the piston rod.
Lateral loads produce false measurement results and may
damage the measuring system.
Festo – DDPC – 1207NH English
80
M10
[Nm] 10 + 2
Quadruple screw connection with FNC flange
mounting in the threaded holes of the cover
screws
100
M10
10 + 2
Fig. 2
Fig. 3
5
19