To Use The Fuel Switch; To Adjust The Skid Plates; To Use The Choke Control; To Prevent Freeze-Up After Use - Husqvarna ST 224 Manual De Usuario

A

To use the fuel switch

• Slide the fuel switch (A) to open or close the fuel
valve. Operate the product with the fuel switch in
the OPEN position.
A

To use the choke control

• Slide the choke (A) to open or close the choke
valve. Use the choke to start a cold engine.
1481 - 004 - 14.04.2021
A

To adjust the skid plates

The skid plates prevent damage to the bottom of the
snow thrower. Adjust the skid plates (A) when the
locknut (B) is loose, or the skid plate is not at the
correct distance from the ground. No adjustment is
necessary for standard installation.
1. Loosen the locknut (B) with a 13 mm (½ in.) open
wrench.
2. Move the skid plates (A) up or down.
a) On flat surfaces set the distance between the
scraper bar and the ground to 5-6 mm
(0.2-0.25 in).
b) On rough surfaces set the skid plates (A) in a
position where the scraper bar is above the
top of the ground.
WARNING: Make sure that
gravel and stones do not go into
the product. Objects that eject at
high speed can cause injury.
3. Tighten the locknut (B).

To prevent freeze-up after use

Note: Controls and moving parts can be blocked by
ice. Do not apply much force to the controls. If you
cannot operate a control or a part, start the engine
and let it operate for some minutes.
A
B
13