Assembly Instructions - Harbor Breeze ANIVA BAY Manual Del Usuario

ASSEMBLY INSTRUCTIONS

1. Remove the preassembled hairpin clip and
clevis pin from the bottom of downrod assembly
(C). Retain pin and clip for later use.
Note: Make sure to keep loose hardware
separate to avoid confusion during installation.
2. Remove the hanger ball portion from the
downrod assembly (C) by loosening the
preassembled set screw in the hanger ball until
the ball falls freely down the downrod. Remove
the preassembled pin from the downrod, then
remove the hanger ball. Retain the pin and
hanger ball for later use.
the downrod support of the motor assembly
(A). Retain the set screws for later use. Then,
route the black, white and blue wires from the
motor assembly (A) through the downrod.
Note: Make sure to keep loose hardware
separate to avoid confusion during installation.
1
2
Set screw
3
6
C
C
C
A