Assembly Instructions - Harbor Breeze 00723 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS

13. Attach light kit (H) to switch housing (G). Align
the holes between the switch housing (G) and
light kit (H). Install screws previously removed
(Step 11, page 9) and securely tighten.
14. Install the bulbs (L) into sockets.
15. Remove the preassembled rubber washer, hex nut,
bowl cap (J) and finial (K) from the light kit (H).
13
G
H
14
15
Rubber
washer
Hex nut
J
K
10
ASSEMBLY INSTRUCTIONS
16. Place glass bowl (I) on the preassembled pipe
on light kit (H) until it is flush against the metal
disk. Thread fan pull chain through side hole of
glass bowl (I). Make sure pull chain hangs clear
and is not tangled in light kit (H) socket. Thread
light kit pull chain through center hole of glass
bowl (I).
NOTE: Two people are recommended for this step.
Screw
17. Place previously removed rubber washer
and hex nut (Step 15, page 10) onto the pipe
and securely tighten. Pass the fan pull chain
through the side hole of the bowl cap (J), then
place bowl cap (J) and finial (K) over pipe and
securely tighten.
L
18. Attach the fan pull chain extension (CC)
and light kit pull chain extension (DD) to
corresponding chains.
Hardware Used
CC
Fan Pull Chain Extension
DD
Light Pull Chain Extension
16
I
17
Hex nut
J
K
18
x 1
x 1
CC
DD
11
Rubber
washer
D

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

0807420

Tabla de contenido