User Mode - Pulsar ACCOLADE 2 LRF Manual Del Usuario

The devices have four operating modes of the
Operating
thermal imager: Forest (observation mode of
mode
objects within low thermal contrast conditions),
Rocks (observation mode of objects within high
thermal contrast conditions), Identification (high
detalization mode), User (individual brightness and
contrast settings).
Press and hold the Menu button to enter the
=
menu.
Select the 'Operating mode' option.
=
A short press of the Menu button opens the menu.
=
Select one of the settings described below with
=
the UP / DOWN buttons.
A short press of the Menu button confirms the
=
selection.
ROCKS MODE – This is the best mode when
observing objects after a sunny day or within urban
conditions.
FOREST MODE – This is the best mode when
searching and observing within field conditions,
against the background of leaves, bushes and
grass. The mode is highly informative about an
object being observed as well as landscape details.
IDENTIFICAION MODE – This is the best mode
when observing objects within adverse weather
conditions (fog, mist, rain and snow). It allows you to
recognize the characteristics of an object being
observed more clearly. Zoom increase may be
accompanied by insignificant image graininess.
USER MODE – It allows you to configure and save
custom brightness and contrast setti
Note: Quick activation of the operating modes is
possible by using the DOWN button (5). Long press
of the DOWN button (5) activates the switching of
the operating modes.
Color
Selecting colour palette
palettes
Basic image mode is «White Hot»
=
To select another palette:
=
Press and hold down the М (3) button to enter the
=
main menu.
Select the desired palette with the UP (2)/
=
DOWN (5) buttons.
Confirm your selection with a brief press of the
=
M (3) button.
Black Hot palette (white colour corresponds to
low temperature, black colour – to high
temperature)
Red Hot
Red Monochrome
Rainbow
Ultramarine
Violet
Sepia
Note: A long press of the UP (2) button also
activates the change of a color palette.
Selecting calibration mode
Calibration
There are three calibration modes: manual (M),
semi-automatic (SA) and automatic (А).
Press and hold down the М (3) button to enter the
=
main menu.
Select the desired calibration mode with the UP
=
(2)/DOWN (5) buttons.
Confirm your selection with a brief press of the M
=
button.
More details in the section «Sensor calibration».
Selection of the Picture in Picture Mode
PiP Mode
Press and hold the Menu button (3) to enter the
=
menu.
Select the 'PiP Mode' option
=
A short press of the Menu button (3) switches the
=
mode on/off.
Wi-Fi Wi-Fi setup
settings
This menu option allows you to set up your device
for operation in a Wi-Fi network.
This menu option allows you to set a password to
Password
access your thermal imager from an external
setup
device.
12345
The password is used to connect an external device
(i.e. smartphone) to your thermal imager.
Press and hold down the М (3) button to enter the
=
main menu.
Select the menu option with the UP (2)/ DOWN (5)
=
buttons.
Press briefly the M (3) button to enter submenu
=
«PAS».
The default password (12345678) will appear on
=
the screen.
7