Usb Connection - Pulsar ACCOLADE 2 LRF Manual Del Usuario

19
FUNCTION PiP
PiP («Picture in Picture») allows you to see
a zoomed image simultaneously with the
main image in a dedicated window.
Enabling / disabling the PiP function is
carried out in the main menu (see section
13 "Main menu functions").
Change zoom ratio in the PiP window with a short press of the DOWN
button.
The zoomed image is displayed in a dedicated window, with the full
optical magnification being shown.
The main image is shown with optical magnification ratio which
corresponds to ratio x1.0.
When PiP is turned on, you can operate the discrete and continuous
digital zoom. The full optical magnification will take place only in the
dedicated window.
When PiP is turned off, the image is shown with the optical
magnification set for the PiP function.
20
STREAM VISION
Accolade 2 LRF thermal imaging binoculars support Stream Vision
technology which allows you to stream an image from the display of
your thermal imager to a smartphone or tablet PC via Wi-Fi in real time
mode. You can find further guidelines on Stream Vision on our web site
www.pulsar-vision.com
Note: the Stream Vision application allows you to update the firmware
features of your thermal imager.
How to update instructions are as below:
1. Download free of charge Stream Vision App on
Store. Scan the QR codes to download Stream Vision free of charge:
2. Connect your Pulsar device to your mobile device (smartphone or
tablet).
3. Launch Stream Vision and go to section "My Devices".
6.9x
3.1x
Google Play or App
4. Select your Pulsar device and press "Check Updates".
Important:
- if your Pulsar device is connected to phone, please turn on "Mobile
data transfer" (GPRS/3G/4G) to download update;
- if your Pulsar device is not connected to your phone but it's already in
the "My Devices" section, you may use Wi-Fi to download update.
5. Wait for the update to download and install. Pulsar device will reboot
and will be ready to operate.
21

USB CONNECTION

Connect one end of the USB cable (16) to the Micro-USB (15) port of
your device, and the other end to the USB port of your PC/laptop.
Turn the device on with a short press of the ON/OFF (1) button (device
that has been turned off cannot be detected by your computer).
Your device will be detected by the computer automatically; no drivers
need to be installed.
Two connection modes will appear
on the display:
Memory card (external memory)
and Power.
Select connection mode with UP
and DOWN buttons.
Confirm selection with a short press of the M button.
Connection modes:
Memory card (external memory).
In this mode the device is detected by the computer as a flash card.
This mode is designed for work with the files saved in device's
memory. The device's functions are not available in this mode; the
device turns off automatically.
If video recording was in progress when connection was made,
recording stops and video is saved.
When USB is disconnected from the device where connection is in
the USB Mass storage device mode, the device remains on the OFF
state. Turn the device on for further operation.
Power.
In this mode PC/laptop is used as an external power supply. The
status bar shows icon
functions are available.
Note: The Battery pack installed in the device is not being charged!
When USB is disconnected from the device when in the Power mode,
the device keeps operating with Battery Pack, if available, and it has
sufficient charge.
USB connection
Use as power
Use as memory card
. The device continues operating and all
13