Worx WG168E Manual Original página 14

• Pull the line from the new replacement Spool
through the eyelet of the Spool Holder.
• Place new Spool into the holder with the
cut out areas of the Spool facing inward
or down. when installed into the Spool
holder, the smooth side of the Spool
should be visible.
• Release line from cleat on the Spool.
• Refit the Spool Cap Cover.
TO MANuALLy wIND LINE
(See Fig. k1-k4)
Take approximately 6m of line. Insert 2mm
of line into the Spool holes and wind line in
the direction of the arrows on the top of the
Spool.
Leave approximately 100mm of line unwound
and place into the cleat.
Ensure that the line is neatly coiled on
the Spool. Failure to do so will impair the
efficiency of the automatic line feed.
Then fit the Spool as described above in
"Replace the trimmer line and Spool"
sTorING yoUr GrAss
14
TrImmEr
Always remove the battery pack
from your trimmer after use.
Store in a dry place where the trimmer and
battery can be protected from damage.
mAINTENANCE
Always remove the battery pack
from your trimmer after use.
Always check the product prior to being used
for any damage.
Never operate your product if it is damaged
Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep
all working controls free of dust.
Cordless Lawn Trimmer/Lawn Edge Trimmer EN