Continuity Testing - Beta 1760PA/AC-DC Manual Del Usuario

CONTINUITY TESTING

1 Set the function switch to [
2 Press the [MODE] button to select the Continuity Test range. The meter automatically defaults
to Resistance.
3 Insert the red test lead into the [V Ω TEMP HZ] input terminal and the black lead to the
[COM] terminal.
4 Short the tip of the test leads and make sure the display reads "0" and the buzzer beeps.
5 Connect the tip of the test leads to the circuit or component under test. The display reads the
resistance and the buzzer beeps when the reading is not more than about 35Ω.
Note:
• Using resistance and continuity function in a live
circuit will produce false results and may damage the
instrument.
• In many cases the suspicious components must be
disconnected from the circuit under test to obtain
accurate results
• WARNING before attempting to make a test, ensure
there is no voltage present on the circuit.
Ω ] range position.
46