Setting The Timer - Mitsubishi Electric PAR-FL31MA Libro De Instrucciones

5-4. Setting the Timer

˚C
PM
NOT AVAILABLE
ON/OFF
MODE
CLOCK
FAN
VANE STOP START
HR. MIN.
˚C
AM
NOT AVAILABLE
ON/OFF
MODE
CLOCK
FAN
VANE STOP START
HR. MIN.
Note:
™ The operation mode, pre-set temperature and the fan speed will be displayed during Start Timer
operation, but the air-condition will not start until the pre-set start time is reached.
™ The blowout direction cannot be changed once the Start Timer setting is completed.
12
Stop Time Setting
The air-conditioner stops operation when the pre-set time is reached.
(The time can be set in steps of ten minutes.)
e.g. To make the operation stop at 6:00 pm.
1. If the LCD displays are not on, press the POWER ON/OFF but-
ton.
2. Press the STOP button (TIMER SET).
™ Check that "
™ To cancel, press the STOP button once again.
3. Press the HR. and MIN. buttons.
™ Adjust the displayed time to 6:00 pm.
™ When "
" is not displayed, time setting cannot be carried out.
In this case, press the STOP button again to cause "
displayed.
When the time is set, the Stop Timer setting is completed.
™ When the Stop Timer is set, the set time will be displayed instead
of the current time.
During the setting of Stop Timer, " " will be displayed but " " will
not be displayed.
Start Timer Setting
The air-conditioner stops operation when the pre-set time is reached.
e.g. To cause the operation to start at 9:00 am.
1. If the LCD displays are not on, press the POWER ON/OFF but-
ton.
2. Press the START button (TIMER SET).
™ Check that "
™ To cancel, press the START button once again.
3. Press the HR. and MIN. buttons.
™ Adjust the displayed time to 9:00 am.
™ When "
" is not displayed, time setting cannot be done.
In that case, press the START button again to cause "
displayed.
When the time is set, the Start Timer setting is completed.
™ When the Start Timer is set, the set time will be displayed instead
of the current time.
During the setting of Start Timer " " will be displayed but " " will
not be displayed.
" and " " are displayed.
" and " " are displayed.
" to be
" to be