Manitou 3-E2 Serie Manual De Reparación página 117

REMOVING THE TELESCOPING CYLINDER
REMOVING OF THE TELESCOPING CYINDER
- Set the forklift truck on a horizontal surface with the handbrake engaged and the gear reverser
set to neutral.
- Telescope slightly to access the shaft in the head of the telescoping cylinder and then expel it
(Item. 1 Fig. A)
- Remove the plate in the base of the jib (Item. 2 Fig. B).
- Disconnect the telescoping cylinder's hoses. Plug the orifices of the telescoping cylinder's two
hoses (Item. 3 and 4 Fig. C).
- Expel the shaft from the base of the telescoping cylinder (Item. 5 Fig. D).
- Remove the cylinder from the back of the jib taking care when drawing out the hoses (Fig. E).
Fig. A
Fig. D
5
Fig. B
1
Fig. E
2
18
Fig. C
4
3