AmpPanel&Controls; Volume Control - Monitor Audio WS-10 Manual Del Usuario

AmpPanel&Controls
1
2
3
4
5
6
1.

Volume Control

This control allows the level or volume to be adjusted in order to achieve a balanced overall sound. To get the balanced sound
a selection of familiar music or film excerpts will need to be played. Start with the volume at minimum and increase the level
control until a balanced sound is established.
If using an AV processor or AV receiver amplifier, the system can be adjusted by the test tone function within the set-up
features. (Refer to the set up section in the AV processor or AV receiver amplifier user guide.) When the subwoofer is correctly
set-up, you should not be able to identify its location easily in the room.
2. Bass Switch
This switch tailors the bass response of the subwoofer to your tastes. There are three settings: Music, Movie and Impact.
Movie mode has been developed for a combination of low bass and level; it goes down to 40Hz @ -6dB. Music goes down
to 40Hz as well but this gives a flatter response. Impact has 2dB gain for maximum output power but at the expense of low
bass (47Hz @ -6dB).
7
monitoraudio.com
8
3