GE CV48S Manual Del Propietario E Instalación página 16

2B
Alternate Mounting Method
INSTALL HOOD TO SOFFIT OR BENEATH CABINETS
SKIP THIS STEP IF USING WALL MOUNTING
METHOD
When necessary, the hood may be installed so that it
is supported by the soffit.
cabinet or soffit.
10" round duct and clearance to slide the hood back
against the wall.
A
chart, Dim. A. to accept mounting screws.
"A" Centerline to Stud
and Keyhole Slots
CV48S
A
2"
10"
7-1/2"
2-9/16"
shown in the top view illustration.
16
Installation Instructions
Requires 10-1/2" Min.
Opening For Ductwork
and Hood Installation
A
"B" Hood Width At
the Top
23-9/16" 47-15/16"
Top View
Front of Hood
B
Back of Hood
IMPORTANT: Soffit framing must be capable of
supporting up to 150 lbs.
Check to be sure the damper moves freely.
Mount Hood onto Soffit or Cabinet
NOTE: If mounting to the underside of a cabinet with a
recessed bottom, install shims to fill the gap.
Engage Top
Keyhole Slots
protrude 1/4". The 1/4" gap will provide clearance to
engage the keyhole slots in the top of the hood.
and route through the knockout (from the back or
top of the hood).
the rear wall.
IMPORTANT: For additional support and to
minimize vibration during operation, the hood must
be secured to the back wall. Use wall anchors to
fasten bottom back of hood to the wall.
3/4"
Cabinet
or
Soffit
Add Shims
1/4" Gap
If Bottom
Is Recessed
Push Back Back
to Wall
Wall
49-80819