Install Hood Onto Wall - GE CV48S Manual Del Propietario E Instalación

2A

INSTALL HOOD ONTO WALL

SKIP THIS STEP IF INSTALLING BENEATH A
SOFFIT OR CABINET, GO TO STEP 2B.
then install 2 screws through the wood support into
the stud that is located, vertically aligned with the
screws located ½" from the edge of the wood support.
below the 15-3/8" marked line.
15-3/8"
30"
to
36"
using at least 2 of the 4 supplied long screws. For the
30" model, you may need to add framing to existing
framing to secure the wood support to 2 studs.
IMPORTANT: Screws must penetrate at least 1" into
vertical studs. Countersink screws into support.
NOTE: The mounting screws
must remain in their original
shipping location. These
screws are positioned
to engage the
keyhole slots in
the back of the
hood.
1/4"
Gap
Adjust depth of original mounting screws in the
wood support until they protrude 1/4" forward. This
1/4" gap will provide clearance to hang the hood.
49-80819
Installation Instructions
Wood
Support
Centerline of
Installation
Space
Original Mounting
Screws as Shipped
IMPORTANT: Framing must be capable of
supporting up to 150 lbs.
Check to be sure the damper moves freely.
Hang Hood On Wood Support
location. Route house wiring through the knockout
and into the junction box.
mounting screws engage the keyhole slots in the
back of the hood. Tighten the screws.
30"
to
36"
wood support.
pilot hole enters a stud, use a washer and the long
wood screw. If the pilot hole does not enter a stud,
enlarge the hole to 3/8" to accept the wall anchor, and
use a washer and the screw from the wall anchor.
Centerline of
Installation
Space
15