Infant Car Seat Installation; S924700 Peg Perego Primo Viaggio 4.35 Sip & Sip 30 - Britax BOB SINGLE Instrucciones

INFANT CAR SEAT
INSTALLATION
S924700 ICSA PEG PEREGO
PRIMO VIAGGIO 4.35,
SIP & SIP 30/30
Failure to properly secure
Restraint Belt and to properly
install Infant Car Seat on Infant
Car Seat Adapter may result
in accident, injury or death.
1. Prepare Stroller
Set parking brake, rotate canopy towards
handlebar, place Restraint Belt ends to the
sides of stroller seat (see stroller owner' s
manual if necessary).
2. Align Infant Car Seat
Place Infant Car Seat "rear facing" directly
centered on top of ICSA, align Groove
Feature on Infant Car Seat with Middle
Tube on ICSA.
3. Verify Infant Car Seat is Latched
Properly
Push Infant Car Seat straight down
on ICSA, look and listen for each
respective Latch Feature on bottom
of Infant Car Seat to latch onto Latch
Tube on ICSA.
CLICK
4. Verify Infant Car Seat is Securely
Attached
Pull up on Infant Car Seat Carry
Handle to verify Infant Car Seat is
securely attached.
5. Securing Restraint Belt
Proceed to section titled "Securing
Restraint Belt" (pg.13).
CLICK
12
P637000A